BKPYQ - WHITE RUBBING COMPOUND, 101S

Product Identification

Product ID:WHITE RUBBING COMPOUND, 101S
MSDS Date:02/02/1989
FSC:8010
NIIN:00N015247
MSDS Number: BKPYQ

Responsible Party
E. I. DUPONT DE NEMOURS & CO
1007 MARKET STREET
WILMINGTON, DE 19898
US

Emergency Phone: 800-441-3637

Info Phone: 800-441-7515

Cage: 73925

Contractor
E.I. DUPONT DE NEMOURS & CO
WILMINGTON, DE 19898 US

Telephone: 800-441-7515;800-441-9442

Cage: 18873

Ingredients

SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293


CASTOR OIL, SULFONATED, SODIUM SALT (SULFONATED VEGETABLE

CAS: 68187-76-8

RTECS: FI4230000


1.00.

CAS: 8008-20-6

RTECS: OA5500000


1.00.

CAS: 8002-09-3

RTECS: TK5100000


23.60.

CAS: 7732-18-5

RTECS: ZC0110000

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHAL: MAY CAUSE NOSE & THROAT IRRIT.
MAY CAUSE NERV SYS DEPRESS CHARACTERIZED BY THE FOLLOWING
PROGRESSIVE STEPS: HDCH, DIZZ, NAUS, STAG GAIT, CONFUSN, UNCONS.
RPTS HAVE ASSOC RPTD & PRLNGD OVEREXP T O SOLV W/PERM BRAIN & NERV
SYS DMG. SKIN/EYE: MAY CAUSE IRRIT/BURNING OF EYES. RPTD/PRLNGD LIQ
(SEE EFTS OF OVEREXP)
Explanation of Carcinogenicity:SILICA-CRYSTALLINE QUARTZ: GROUP 2A.
KEROSENE, CAS NO. 8008-20-6: IARC GROUP 2A (FROM RTECS).
Effects of Overexposure:HLTH HAZ: CONT MAY CAUSE SKIN IRRIT
W/DISCOMFORT & DERMAT. QUARTZ-CRYSTALLINE SILICA: RPTD OVEREXP TO
CRYSTALLINE SILICA MAY LEAD TO TYPICAL X-RAY CHANGES AND CHRONIC
LUNG DISEASE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL: IF AFFECTED BY INHAL OF VAP/SPRAY MIST, REMOVE TO
FRESH AIR. IF NOT BRTHG, GIVE ARTF RESP, PREF MOUTH-TO-MOUTH. IF
BRTHG DIFFICULTY PERSISTS, OR OCCURS LATER, CALL MD. SKIN/EYE:
IMMED FLUSH W/P LENTY OF WATER FOR AT LEAST 15 MIN; CALL MD. SKIN:
WASH W/SOAP & WATER. IF IRRIT OCCURS, CALL MD. INGEST: GI DISTRESS.
IN UNLIKELY EVENT OF INGEST, CALL MD IMMED & HAVE NAMES OF INGRED
AVAIL.

Fire Fighting

Flash Point Method:CC
Flash Point:100F,38C
Lower Limits:0.7%
Upper Limits:7.0%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP .
WATER FROM FOG NOZZLES MAY BE USED TO PREVENT PRESSURE BUILD-UP.
Unusual Fire/Explosion Hazard:WHEN HEATED >FL PT, EMITS FLAM VAPS
WHICH, WHEN MIXED W/AIR, CAN BURN OR BE EXPLO. FINE MIST/SPRAYS MAY
BE FLAM AT TEMPS BELOW FL PT.

Accidental Release

Spill Release Procedures:VENT AREA. REMOVE SOURCES OF IGNITION. PREVENT
SKIN CONTACT AND BREATHING OF VAPOR. CONFINE AND REMOVE WITH INERT
ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:OBSERVE LABEL PREC. KEEP AWAY FROM
HEAT, SPARKS AND FLAME. CLOSE CNTNR AFTER EACH USE. GROUND CNTNRS
WHEN POURING. DO NOT STORE ABOVE 120F.
Other Precautions:DO NOT SAND, FLAME CUT, BRAZE OR WELD DRY COATING
WITHOUT A NIOSH/MSHA APPROVED RESPIRATOR OR APPROPRIATE
VENTILATION.

Exposure Controls

Respiratory Protection:DO NOT BREATHE VAPS/MISTS. WEAR A PROPERLY
FITTED NIOSH/MSHA APPRVD VAP/PARTICULATE RESP FOR USE W/PAINTS
DURING APPLICATN & UNTIL ALL VAPS & SPRAY MISTS ARE EXHAUSTED.
FOLLOW RESP MFR DIRECTIONS FOR RESP USE.
Ventilation:PROVIDE SUFFICIENT VENT IN VOLUME & PATTERN TO KEEP
CONTAMINANTS Protective Gloves:NEOPRENE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:COVERALLS. PROTECTIVE CREAMS MAY BE USED FOR
EASE OF CLEAN UP.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
EATING OR SMOKING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:32.0F,0.0C
Vapor Pres:SEE INGRED
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:APPRECIABLE
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:53.0

Stability

Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORESEEABLE.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CO, CO*2, SMOKE, OXIDES OF HEAVY
METALS REPORTED IN HEALTH HAZARDS.

Disposal

Waste Disposal Methods:DO NOT ALLOW MATL TO CONTAMINATE GROUND WATER
SYSTEMS. INCIN ABSORBED MATL IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REQ. DO NOT INCINERATE IN CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.